For adhesive tape, protective film, paper products precision cutting, the conventional large roll of materials, cut into the specified width. In the man-machine interface, set the width, frequency and Angle of the machine, and the machine performs according to the set parameters.
For adhesive tape, protective film, paper products precision cutting, the conventional large roll of materials, cut into the specified width. In the man-machine interface, set the width, frequency and Angle of the machine, and the machine performs according to the set parameters. There are 10 modes to choose from. After cutting the width of the first mode, the width of the second mode is set immediately. And so on, until the complete branch material is cut off. Greatly improve the production efficiency.
Generally equipped with an alloy round knife of high precision material, with automatic spray type silicone oil cooling, so as to achieve a non-adhesive knife, keep the sharp effect, but also will not wet the material. The machine is equipped with underpressure protection and light control protection device, in the safety is also made a great measure.
The traditional control scheme of the cutting machine is to use a large motor to drive the shaft of receiving and winding. The magnetic powder clutch is added on the reel. It controls the resistance generated by adjusting the current of the magnetic powder clutch, so as to control the tension of the material surface. Magnetic powder clutch and brake are a special automatic execution element, which transmits the torque through the magnetic powder filled in the working gap. Changing the magnetic current can change the magnetic state of the magnetic powder, and then adjust the magnetic torque transmitted. It can be used for stepless speed regulation from zero to synchronous speed, suitable for high-speed section fine-tuning and small and medium power speed regulation system. It is also used for an open winding or rewinding tension system that adjusts the torque by adjusting the current to ensure that the tension remains constant during the winding process.